11-09-2009 07:50 PM - edited 07-03-2021 06:14 PM
Hi
we have AP1130 all these days it is working but today it laptop was connecting when logged in to wireless I found Radio0-not installed Radio1-not installed. apparently it went in to repeater mode. can any one help me pn this
Thanks
SP
11-10-2009 03:54 AM
Try configuring it from the CLI:
ap1130# configure terminal
ap1130(config)# interface dot11radio 0
ap1130# configure terminal
ap1130(config)# interface dot11radio 1
11-10-2009 01:41 PM
I tired
it not showing that interface
ap#sh run
Building configuration...
Current configuration : 814 bytes
!
version 12.4
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname ap
!
enable secret 5 $1$a9ZM$8sgxHJWQeyjsPeL3Ji84F1
!
no aaa new-model
ip domain name sch.com.au
!
power inline negotiation prestandard source
!
!
username Cisco password 7 047802150C2E
!
bridge irb
!
!
interface FastEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address 192.168.1.100 255.255.255.0
no ip route-cache
!
ip default-gateway 192.168.1.1
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
!
end
ap#
11-10-2009 10:06 PM
RMA it. The radio controllers are kaput.
11-11-2009 06:24 AM
Haha, well said Leo.
11-11-2009 01:45 PM
Hi Jeff,
I'm serious! The radios have "left the building". I had the same thing on a 1242 a few weeks ago. Radio01 is no longer in the "sh ip interface brief" and Radio0 is on "reset" 9 minutes after a reboot.
:)
11-11-2009 01:57 PM
can you tell me what is RMA
02-24-2015 09:02 PM
this is my exact problem yesterday...
first time to get this error...
ap's have been working for more than 5 years until yesterday...
hehehe... WOTD... "kaput"
03-05-2018 07:05 PM
1.) upgraded IOS to 12.3(8)JEA3
Wow. OLD IOS. Try going for the 12.4 version.
Can I ask you to console into the AP and boot the AP? Post everything. I'm suspecting one of two things:
1. Radio is looking for the image but couldn't find it.
2. Radio has crashed or gone defective. Only the bootup process with show.
Also post the output for the command "di
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: