E1 flap

Unanswered Question
Nov 10th, 2009

Dear all,

E1 flap during the past last 3 weeks, and you recommended me this command:

network-clock-select 1 E1 0/1/0

It looks good as this command made 0 Slip Secs & 0 Errored Sec.

But, E1 still flap again, if i can increase the priority again from 1 to 8 or it will do nothing and if so, no other recommendation can be done from my side.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ahmed Yassin Wed, 11/11/2009 - 00:43

E1 cable is 2 pairs and made from 3 years ago from starting of E1 service.

It working but suddenly down then up again at the same moment. So, any call will be terminated.

I am talking about the command shown aboe, if i can increase the priority or no.

Paolo Bevilacqua Wed, 11/11/2009 - 12:24

I was asking: how many flaps do you have each day ?

Changing priority doesn't make a difference.

sebastiandm Thu, 11/12/2009 - 03:15

Hi,

Do a clear counters and then sh int serial 0/1/0:15 after about an hour...post the results.

Paolo Bevilacqua Fri, 11/13/2009 - 06:44

Open a ticket with telco.

They will say that everything is OK, at which point you will have to ask for diagnostic equipment be put inline.

Actions

This Discussion