Dear all
I am having a problem in my C4006 during the boot.
While Booting the switch, i get in the end the following error: "Your ROMMON version is obsolete"
I tried to download another IOS and boot the switch using the boot tftp command from the rommon mode but still had the same problem,
I put below the whole BOOT log that i am receieving, please advise what to do to boot the Switch successfully as it is urgent.
rommon 15 >boot tftp://10.100.100.155/cat4000-i9s-mz.122-18.EW7.bin
Tftp Session details are ....
Filename : /cat4000-i9s-mz.122-18.EW7.bin
IP Address : 10.100.100.1
Loading from TftpServer: 10.100.100.155
Received data packet # 20078
Loaded 10279472 bytes successfully.
Rommon reg: 0x37004180
Running diags...
Decompressing the image
########################## [OK]
k2diags version 2.4.2_b
prod: WS-X4014 part: 73-6854-08 serial: JAB061405LZ
ManPm8351: using limited loopback
ManPm8351: using limited loopback
ManPm8351: using limited loopback
ManPm8351: using limited loopback
Power-on-self-test for Module 1: WS-X4014
Port/Test Status: (. = Pass, F = Fail)
Reset Reason: Software/User
Port Traffic: L2 Serdes Loopback ...
0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: .
12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: .
24: . 25: . 26: . 27: . 28: . 29: . 30: . 31: .
Port Traffic: L2 Asic Loopback ...
0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: .
12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: .
24: . 25: . 26: . 27: . 28: . 29: . 30: . 31: .
Port Traffic: L3 Asic Loopback ...
0: . 1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: .
12: . 13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: .
24: . 25: . 26: . 27: . 28: . 29: . 30: . 31: . au: .
Switch Subsystem Memory ...
1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: .
13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: .
25: . 26: . 27: . 28: . 29: . 30: . 31: . 32: . 33: . 34: . 35: . 36: .
37: . 38: . 39: . 40: . 41: . 42: . 43: . 44: . 45: . 46: . 47: . 48: .
49: . 50: . 51: . 52: . 53: . 54: .
Module 1 Passed
Exiting to ios...
Rommon reg: 0x37000180
Running IOS...
Decompressing the image
################################################################################################################################################# [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(18)EW7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Fri 13-Oct-06 11:13 by ccai
Image text-base: 0x00000000, data-base: 0x010A6974
####### ###### ###### ####### ###### ###
# # # # # # # # # ###
# # # # # # # # # ###
##### ###### ###### # # ###### #
# # # # # # # # #
# # # # # # # # # ###
####### # # # # ####### # # ###
Your ROMMON version is obsolete
Rebooting in 10 seconds...
10 09 08 07 06 05 04 03 02 01 00
%Software-forced reload
