I have a bunch of VLANs configured on my 6513 FWSM. I wanted all my VLANs to be on there but just found out a requirement to run IRDP. Since IRDP can only be run on a router interface, I had to take this VLAN off the FWSM and put it on the MSFC.
How now do I connect to the servers on in the VLANS on the FWSM?
I have VLAN2 on both the MSFC and the FWSM and they can ping. But from the MSFC I cannot ping any of the other VLAN interfaces on the FWSM.
I put a static route on the MSFC to point to the VLAN2 interface on the FWSM for the subnet but to no avail.
I have attached the relevant show run output for the 6513 and the entire show run from the FWSM.
The goal is to allow vlan 150 on the MSFC to have access to all the vlans on the FWSM.