cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
680
Views
0
Helpful
3
Replies

NM16ESW with HWIC-4ESW IN 2811 CHASSIS

jpzarate
Level 1
Level 1

Hello,

I would like to know if some configuration exists so that these two cards work simultaneously. Since only HWIC works me. And when I remove HWIC it works me the NM-16ESW.

I ignore if you can configure a stack among both cards, or other solution.

Thank you

1 Accepted Solution

Accepted Solutions

Amit Singh
Cisco Employee
Cisco Employee

Intra-chassis stacking is not possible with these two modules. You can run an ether-port from each module and cofigure it as a dot1q trunk in order to have ports in the same domain and configure them accordingly.

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_qas0900aecd8016c026_ps5854_Products_Q_and_A_Item.html

HTH,

-amit singh

View solution in original post

3 Replies 3

glen.grant
VIP Alumni
VIP Alumni

If you want both I believe you have to stack the cards together in order for both to work otherwise you can only have 1 installed . Do a search on the main page for stacking those hwics togther.

The problem is that the stack between two model different from cards not you if it is possible. Since serious a stack with one HWIC-4ESW and NM-16ESW.

Thanks

Amit Singh
Cisco Employee
Cisco Employee

Intra-chassis stacking is not possible with these two modules. You can run an ether-port from each module and cofigure it as a dot1q trunk in order to have ports in the same domain and configure them accordingly.

http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_qas0900aecd8016c026_ps5854_Products_Q_and_A_Item.html

HTH,

-amit singh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco