Busy signal with incoming calls.

Answered Question
Nov 12th, 2009

Hi all, I have a problem with the incoming calls. I hear only one tone and the next a busy signal. I don't know if the configuration is correct, the outgoing calls working fine.

Many thanks for all.

Best Regards.

M.Castilla

Attachment: 
I have this problem too.
0 votes
Correct Answer by Steven Smith about 7 years 1 month ago

This community is for Cisco Small Business products such as the UC500, not the 1700.

Looking at the config, I see no inbound dial peers or routing for the inbound dial peers. 

These might help.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010ae1c.shtml

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

If you still need help, I would recommend the netpro forums.

www.cisco.com/go/netpro/

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (1 ratings)
Loading.
Correct Answer
Steven Smith Thu, 11/12/2009 - 10:31

This community is for Cisco Small Business products such as the UC500, not the 1700.

Looking at the config, I see no inbound dial peers or routing for the inbound dial peers. 

These might help.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010ae1c.shtml

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

If you still need help, I would recommend the netpro forums.

www.cisco.com/go/netpro/

Actions

This Discussion