cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
834
Views
0
Helpful
3
Replies

ACL in Controller 4404

paulo.s
Level 1
Level 1

Hi.

I read CWCS Configuration Guide release 5.1 about ACL, applied ACL to WLAN, but didn't work.

I want to restrict wireless client access any networks.

If anyone knows, please help me.

Thks.

Paulo Maurício

1 Accepted Solution

Accepted Solutions

dancampb
Level 7
Level 7

Keep in mind with ACLs on the controller they are written with the assumption that you are on the controller and traffic is coming from the wireless clients in regards to the inbound and outbound directions. Also you need to write an inbound and outbound rule for each condition. They aren't like IOS ACLs that will automatically allow the return traffic through.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807810d1.shtml

View solution in original post

3 Replies 3

dancampb
Level 7
Level 7

Keep in mind with ACLs on the controller they are written with the assumption that you are on the controller and traffic is coming from the wireless clients in regards to the inbound and outbound directions. Also you need to write an inbound and outbound rule for each condition. They aren't like IOS ACLs that will automatically allow the return traffic through.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807810d1.shtml

Thks for help.

I will test.

Ok, it works!!!

I found the error. I was configuring by WCS, and when I configured protocol to ANY, returned this message: Protocol : 256 : Value for this attribute is invalid. (Valid Range: is 0 <> 255 )

My WCS version is Version 5.1.64.0, and controller software version is 4.2.112.0.

Thks for help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: