RME 4.2 NetConfig deploys truncated MOTD

Unanswered Question
Nov 13th, 2009

Using the out-of-the-box Banner template, RME 4.2 NetConfig reported deployment was successful on a CatOS 8 switch during both test runs. However, post baseline shows the MOTD is truncated and thousands of blank lines were inserted.

Is there any known issue or caveat with this template or NetConfig? I've attached both NetConfig job directories and pre/post switch config baslines to TAC case 612974651.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Fri, 11/13/2009 - 10:06

There are no known issues with NetConfig on CatOS which would explain this. However, I'm not sure how many people were using this template on CatOS, though. You may very well have found a new bug.

Actions

This Discussion