State interface in the ARP Table

Unanswered Question
Nov 13th, 2009

I keep receiving the following msg every 10min.

"Deny inbound UDP from to on interface inside"

I have discovered the ip is located in my ARP Table with the interface set to STATE.Please help.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mkharban Fri, 11/13/2009 - 10:00


You are getting this message because there is no natting done for It looks like the STATE interface has a higher security level than the interface from which is coming.

Hope this helps!



Cisco TAC


This Discussion