cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
292
Views
0
Helpful
1
Replies

Cisco 877 and Port Forwarding

panitaxx1
Level 1
Level 1

Hello,

I have a cisco 877 with 3 vlans and and atm interface with a bvi interface.

Vlan 2 and 4 : are nat inside. two different subnets

Vlan 3: bridged directly to atm.

BVI1: nat outside. gets its ip address via dhcp.

I have some static nat port translations from bvi1 to some vlan4 hosts.

Everything works fine. The problem is that when I power cycle the router or the dsl (atm) goes down and then up the nat translations stops working. To work I have to erase the translations and create the again.

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Try updating IOS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco