reg:2960switch

Unanswered Question
Nov 16th, 2009

Dear sir,

Ihave cisco 2960 l2 switch in that out of 24 port iwant to use two ports are HUB ports .Is it possible.

plz give me config example

srini

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Mon, 11/16/2009 - 23:39

Hello Srini,

if you want to connect two hubs on two ports of C2960 this is possible.

just verify that you haven't port security enabled on the ports.

default configuration should be enough.

you may want to set speed and duplex to half.

be aware that hubs work only in half-duplex mode.

I recommend to enable spanning-tree bpduguard

int f0/5

switchport

switchport mode access

switchport access vlan 5

spanning-tree bdpuguard enable

this should be fine

Hope to help

Giuseppe

Actions

This Discussion