Sir,

Thank you for visiting Cisco Community Forum.

Note: For the AP Client and Wireless Bridge Modes, the remote access point must be a second Linksys Wireless-G Access Point. For the Wireless Repeater mode, the remote wireless bridge must be a second Linksys Wireless-G Access Point or Wireless-G Router.

The WAP200E uses WDS (http://en.wikipedia.org/wiki/Wireless_Distribution_System) - WDS may be incompatible between different products (even occasionally from the same vendor) as it is not certified by the Wi-Fi Alliance

http://www.cisco.com/en/US/products/ps10047/products_qanda_item09186a0080a38f1f.shtml

It may be possible to bridge different models if they also use WDS where you can match up the MAC addresses on both sides.

Thanks,

Jeff.