cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
350
Views
0
Helpful
1
Replies

Router E1 log

ricardorojas123
Level 1
Level 1

Hi, when I enter the command "pri-group timeslots 1-31" under the second controller in the Router, this messages is showed:


Router3800(config)#controller E1 0/0/1

Router3800(config-controller)# pri-group timeslots 1-31

% Not enough DSP resources available to configure pri-group on controller E1 0/0/1

% The remaining dsp resources are enough for 26 time slots.
% For current codec complexity, 1 extra dsp(s) are required to create this voice port.

How I can resolve the problem ?

Thanks

1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

Have you confirmed you DO have enough DSPs free on the router or module where the card is to use it????

The message says that you only have 26 channels available for use.

If you indeed only have 26 channels the options are to only enable the 26 channels or add DSPs


HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: