Unable to specify different VLAN for WLAN, in H-REAP mode

msmith · ‎11-21-2009

I've decided to try to use an existing WLAN and have it working with a new AP in H-REAP mode.

-I've joined the AP to the remote controller, assigned it an IP, put it in H-REAP mode.

-I chose a WLAN, enabled local switching. On the controller, this WLAN uses VLAN 222.

-I went into the AP, configured the native VLAN, that was fin. However, when I try to edit the WLAN VLAN, CAN NOT change it. It always goes back to default (222).

I verified the vlan exists on the switch, is routable, etc, the switch port is a member of that vlan, it is set as a trunk w/ 802.1q, etc.

Any ideas on what would cause this?

I am SOO close Thanks!

msmith · ‎11-21-2009

Ladies and gentleman, does this make sense?

I am using WCS to try and configure this...and that is where I was having trouble. When I pulled up the WLC directly and made the vlan mapping change, it saved and worked fine. Those changes were reflected in WCS also. A bug maybe? This is old 4.2 stuff