11-23-2009 01:28 AM - edited 03-04-2019 06:46 AM
Hello everybody
Im using Cisco router as Tcp to X.25 translator. In Tcp to X.25 conversion during X.25 call setup
Cisco router acts as a XPAD device and send call request along with CUD 0X01000000 which
shows source device (Cisco Router) is a PAD device .
Our X.25 remote device just accept X.25 calls from X.25 source , not XPAD so it rejects the call.
How we can force Cisco router to act as a pure X.25 device (not PAD) or send call request without
XPAD CUD.
Thanks
11-23-2009 02:06 AM
Are you using ALP (AirLine Protocol set) or MATIP (Mainframe To IP)?
11-23-2009 04:09 AM
You can set the value that you want - cud option in translate command.
11-24-2009 04:26 AM
Hi again,
one thing more.
CUD option just adds cud string to call setup and doesn't omit it.
Nov 24 08:34:08.747: Serial0/0/2: X.25 O R1 Call (17) 8 lci 1
Nov 24 08:34:08.747: From (4): 8000 To (4): 4003
Nov 24 08:34:08.747: Facilities: (0)
Nov 24 08:34:08.751: Call User Data (8): 0x01000000 (pad)
0: 10010B44 40038000 ...D@...
8: 00010000 00746573 74 .....test
Nov 24 08:34:08.839: Serial0/0/2: X.25 I R1 Clear (5) 8 lci 1
Nov 24 08:34:08.839: Cause 0, Diag 32 (DTE originated/Packet not
allowed)
0: 100113 0020 ....
Nov 24 08:34:08.839: Serial0/0/2: X.25 O R1 Clear Confirm (3) 8 lci 1
0: 100117 ...
Thx & rgrds
11-24-2009 05:40 AM
You set the value that you want, or null.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: