One question about something I was not able to find in the documentation.
Lets say I have one class-map which includes 2 ports (in this case https and 5061).
Can I associate this class-map to just 1 generic serverfarm and probe for both ports or I have to specify 2 serverfarms/rservers/probes?
So, by not specifying the ports on the rserver, if a request is received on port 443 (or 5061), it is sent to the same respective port on the rserver?
The same way is valid for the generic probe. ACE module is able to probe both ports based on the class-map?
Thanks and have a great day!!
probe tcp PROBE_GENERIC_TCP
description This probe works for all TCP services by inheriting the VIP port.
passdetect interval 15
passdetect count 2
rserver host SERVER1_ACCESS
ip address <1AC>
rserver host SERVER2_ACCESS
ip address <2AC>
serverfarm host ACCESS-SFARM
class-map match-any OCS_L4ACCESS
2 match virtual-address x.x.x.176 tcp eq https
2 match virtual-address x.x.x.176 tcp eq 5061
policy-map type loadbalance first-match OCS_L4ACCESS
policy-map multi-match POLICY
loadbalance vip inservice
loadbalance policy OCS_L4ACCESS
loadbalance vip icmp-reply active
connection advanced-options OCS_VIPTIMEOUT
nat dynamic XXX vlan 503
port inheritance is not yet available on the module.
So, you will need to define 2 probes...one for each port and assign the 2 probes to the serverfarm.
You can however use the same serverfarm with your class-map.
If not port is specified for the rserver, we will reuse the one used by the client to connect to the vip.