Monitor FXS active calls on 2811 with VOICE IOS

Unanswered Question
Nov 23rd, 2009
User Badges:

Hi All,

I have few 2811 some with an NM-HDA-4FXS and others with VIC-4FXS.

I would like to monitor the acitve calls between site but i'm unable to find the right OID.

I have tried the voice MIBs but i'm unable to get a response on most of the OIDs.

I'm able to monitor the interface throughtput

I would need to have the number of active calls or the bandwidth allocated to calls.

I looked all over the place but i cannot find anything relevant.

Could you please help.

Best Regards,


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
rupam_chakra1983 Tue, 11/24/2009 - 01:42
User Badges:

try the commoand " show voice call staus "

This will show you actve calls.

Rate this if found useful

rafik24123 Tue, 11/24/2009 - 02:00
User Badges:

Hi Rupam,

Thank you for your answer,

I've been using this command but i cannot use a script on my NMS.

I'm trying the cva iffxsstatus: #[] from CISCO-VOICE-ANALOG-IF-MIB but this only tells me if the phone if onhook / offhook but

doesnt tell if a call has been initiated.




This Discussion