11-23-2009 07:25 AM - edited 03-15-2019 08:33 PM
Hi All,
I have few 2811 some with an NM-HDA-4FXS and others with VIC-4FXS.
I would like to monitor the acitve calls between site but i'm unable to find the right OID.
I have tried the voice MIBs but i'm unable to get a response on most of the OIDs.
I'm able to monitor the interface throughtput
I would need to have the number of active calls or the bandwidth allocated to calls.
I looked all over the place but i cannot find anything relevant.
Could you please help.
Best Regards,
Rafik
11-24-2009 01:29 AM
Any hint would be highly appreciated
11-24-2009 01:42 AM
try the commoand " show voice call staus "
This will show you actve calls.
Rate this if found useful
11-24-2009 02:00 AM
Hi Rupam,
Thank you for your answer,
I've been using this command but i cannot use a script on my NMS.
I'm trying the cva iffxsstatus: #[1.3.6.1.2.1.2.2.1.2] from CISCO-VOICE-ANALOG-IF-MIB but this only tells me if the phone if onhook / offhook but
doesnt tell if a call has been initiated.
Regards,
Rafik
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: