cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
316
Views
0
Helpful
1
Replies

Etherchannel and Spanning tree

thomuff
Level 3
Level 3

I am using bundling 4 switchport to connect a 4507 to a 3750 for layer2 connectivity.

int g1/0/1 - 4

switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on

Should I configure spanning-tree on these ports or the port-channel interface?

If so, what spanning-tree should I use?

Thanks

1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Thom,

STP handles a bundle as a single link so if you need to tune STP configuration you can do it in port-channel interface mode

you don't need to change STP mode only for this reason.

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco