11-25-2009 08:26 AM
We have a 5010 switch and attempted to connect to an external 1000Base-T switch using the Ethenet Connector Ports (labeled L1 and L2), however, it won't connect out. I think there's something I'm missing but according to the user guide, L1/L2 port is supposed to connect to external router, hub, or switch. So what is the problem? Thanks.
12-10-2009 08:48 AM
Where did you find the information about port L1 and L2 ?
12-11-2009 07:17 PM
The Ethernet Connector can be found from the following link:
01-12-2010 06:30 PM
Colin,
The documention you are citing is general hardware installation and not great in terms of configuration. Think of it as a physical guide to racking, plugging cables in, where to mount brackets and so on.
Use this section in the config guide to configure mgmt0:
L1 and L2 are not active interfaces at this time. In the future, they might be used for vPC (virtual port-channel) communication.
Regards,
John Gill
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide