Solved: Installation LMS3.2 - Regional Settings W2K3

STEFFEN NEUSER · ‎11-25-2009

Hello,

I want to install LMS3.2 at W2K3 server, but the installation will terminate complaining the regional settings, as shown in attached png.

But I set the regional settings to EnUS, as shown in attached png with reboot of the entire server. What did I wrong and what is the LMS installation looking for in real?

Steffen

yjdabear · ‎11-25-2009

If your "systeminfo" output reflects all US English as well, maybe you can give the tip in the last post of this thread a try:

https://supportforums.cisco.com/message/673052#673057

"go to "regionnal setting",tab "advance" ,changed English(US) to FR and then back to English(US), do "Apply all setting to cur.." "

View solution in original post

yjdabear · ‎11-25-2009

If your "systeminfo" output reflects all US English as well, maybe you can give the tip in the last post of this thread a try:

https://supportforums.cisco.com/message/673052#673057

"go to "regionnal setting",tab "advance" ,changed English(US) to FR and then back to English(US), do "Apply all setting to cur.." "

STEFFEN NEUSER · ‎11-25-2009

100 points, problem solved, thx Steffen

yjdabear · ‎11-25-2009

Es war mir ein Vergnuegen.