Catalyst 6509 VSS dual-active recovery

Unanswered Question
Nov 26th, 2009

Hi,

I'm using 2 6509 in VSS (version s72033-ipbasek9-mz.122-33.SXI2a.bin)

EV-SRGI1&2-6509-1#sh switch virtual role

Switch  Switch Status  Preempt    Priority  Role     Session ID
        Number         Oper(Conf) Oper(Conf)         Local  Remote
------------------------------------------------------------------
LOCAL    1     UP      FALSE(N )   110(110)  ACTIVE   0      0
REMOTE   2     UP      FALSE(N )   100(100)  STANDBY  2298   6693


In dual-active recovery mode: No
EV-SRGI1&2-6509-1#sh switch virtual dual-active fast-hello
Fast-hello dual-active detection enabled: Yes

Fast-hello dual-active interfaces:
Port       Local State    Peer Port    Remote State
---------------------------------------------------
Gi1/5/3    Link up        Gi2/5/3      Link up

Dual-active recovery mode works well except when the Inter-VSS link become operational again, the "recovery switch" never reloads to "stanby" because it indicates configuration has been changed and I have to save it before reloading

Is this normal ?

Thanks for help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mmacdonald70 Sun, 12/20/2009 - 07:37

The configuration guide states that the failed switch will not automatically reboot if there has been a change to the config which has not been saved.  Did you perform a cop run sta since the last change?

Actions

This Discussion