11-26-2009 03:23 AM - edited 03-04-2019 06:48 AM
Router(config)#int atm0/0/0.608
Router(config-subif)#pvc 1/608
% Incomplete command.
Router(config-subif)#pvc 1/608 ?
% Unrecognized command
Cisco IOS Software, 1841 Software (C1841-SPSERVICESK9-M), Version 12.4(13a), RELEASE SOFTWARE (fc1)
11-26-2009 06:55 AM
Did you define that subinterface as point-to-point?
For instance:
Router(config)#int atm0/0/0.608 point-to-point
Can you post the show config along with the show diag output?
Regards
Edison.
12-02-2009 03:52 AM
WIC/HWIC Slot 0:
GSI GSHDSL MULTI LINE ATM WIC
Hardware Revision : 0.0
Top Assy. Part Number : 800-26571-02
Board Revision : C0
Deviation Number : 0
Fab Version : 01
PCB Serial Number : FOC11276H30
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Version Identifier : V02
Product (FRU) Number : WIC-1SHDSL-V3
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 04 DA 41 00 00 C0 46 03 20 00 67 CB 02
0x10: 42 43 30 88 00 00 00 00 02 01 C1 8B 46 4F 43 31
0x20: 31 32 37 36 48 33 30 03 00 81 00 00 00 00 04 00
0x30: 89 56 30 32 20 CB 8D 57 49 43 2D 31 53 48 44 53
0x40: 4C 2D 56 33 FF FF FF FF FF FF FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
controller DSL 0/0/0
mode atm
line-term cpe
line-mode auto
dsl-mode shdsl symmetric annex B
interface ATM0/0/0
no ip address
no atm ilmi-keepalive
!
interface ATM0/0/0.608 point-to-point
description
ip address x.x.x.x y.y.y.y
12-02-2009 06:29 AM
Problem solved
for some reason that WIC had the following
Router(config-if)#pvc ?
<0-31> Enter VPI/VCI value(slash required)
<1-255> Enter VCI value
using atm vc-per-vp 2048 the range was extended and it accepted the 608 value
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide