ASA 5550 ACl's

Unanswered Question
Nov 26th, 2009
User Badges:

Hello,


I am carrying out some cleanup tasks on our 5550 firewall; and am using the syntax below in conf t to remove old access-lists (the majority are access lists left from captures etc) :



host# sh access-list CAP1
access-list SL-CAP; 0 elements
host# conf t
host(config)# clear configure access-list CAP1
host(config)# wr
Building configuration...
[OK]
host(config)# end
host# sh access-list CAP1
access-list CAP1; 0 elements


All other access lists apart from this and one other have removed as expected - I have checked to see if the captures are still running, but they have been removed.


Any advice that you could be provide would be greatly appreciated, thankyou in advance!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Tanveer Deewan Thu, 11/26/2009 - 16:37
User Badges:

Hi,


can you get the output of the following?


show run | i CAP1

show run | i SL-CAP

Dale Sanderson Fri, 11/27/2009 - 01:14
User Badges:

Forgive my mistake - there is only one access list I am in reference to -  that was my mistake on failing to sanatise the output properly


In full :


host# sh access-list SL-CAP
access-list SL-CAP; 0 elements
host# conf t
host(config)# clear configure access-list SL-CAP
host(config)# wr
Building configuration...


[OK]
host(config)# end
host# sh run | inc SL-CAP


#no output#


host# sh access-list SL-CAP
access-list SL-CAP; 0 elements


Regards

Actions

This Discussion

Related Content