Monitoring DSP resources, SNMP OID

borkes1985_2 · ‎11-27-2009

Hi again, cisco gurus!

Have been looking for SNMP OID that allows to monitor the number of DSP-channels active on Cisco router for some days.

Has someone investigated this task? completely perplexed

thanks,

Boris Borodin

chris.mann · ‎12-01-2009

Check out this link

http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_dsp_notifications.html#wp1054016

Also some additional information --

dspu—Sends a notification whenever the operational state of the physical unit (PU) or the logical unit (LU) changes or activation failure is detected. This is from the CISCO-DSPU-MIB, and the notifications are:

enterprise 1.3.6.1.4.1.9.9.24.1.4.4

1newdspuPuStateChangeTrap

2 newdspuPuActivationFailureTrap

enterprise 1.3.6.1.4.1.9.9.24.1.5.3

1 newdspuLuStateChangeTrap

2 dspuLuActivationFailureTrap

dsp—Sends a notification whenever the DSP card goes up or down. This is from the CISCO-DSP-MGMT-MIB, and the notification is:

enterprise 1.3.6.1.4.1.9.9.86.2

1 cdspMIBCardStateNotification

Also you could check out these two MIBS, from website http://www.cisco.com/go/mibs

•CISCO-DSP-MGMT-MIB

•CISCO-DSP-MGMT-CAPABILITY-MIB

Hope that helps,

CM

Medved_RC · ‎06-21-2010

Hi! I have similar question.
   I have 2811 that uses like onramp/oframp fax-server.
    I need to monitor number of faxes that DSP is operates in time. I want make some graphs (in cacti or MRTG) that show load dsp
    resources by faxe's for optimizing number of DSP card in router and monitoring max fax load time.
    I search in MIB but couldn't find strict that i want.
    May be you have some solution for such kind of question.
Tank you.

Alejandro Rodriguez · ‎04-14-2011

Medvec_Rc

I have the some problem? Can you resolved it?

I have 2811 that uses like fax onramp, and need the number of fax is received at time.

Who can helpme.