OER policy - Queue

Unanswered Question
Dec 2nd, 2009
User Badges:

Dear Experts,


I am configuring OER and I learned various ways of measuring the traffic and set threshold like delay, Max-xmit, Max-range, Throughput etc.


Is it possible to measure and change the traffic to another exit interface using the output queue of the interface. Putting in simple words. if serial 0/0 interfaces queue reached 80% of the configured value, the subsequent traffic should be diverted to serial 0/1.


I googled and checked with Cisco DOC CDs, but not clues.


Can you please help on this


regards,


sairam

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tomek0001 Mon, 12/07/2009 - 14:48
User Badges:

Sairam

This can be done with the following commands:


oer master

border ip-address [key-chain key-chain-name]

interface type number external

max-xmit-utilization {absolute kbps | percentage value}

end


You can find more information on http://www.cisco.com/en/US/docs/ios/oer/configuration/guide/oer-trf_lnk_util_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1054319


(please rate if helpful)


Let me know if that's what you are looking for.


Regards,


Tom

Actions

This Discussion