12-02-2009 08:13 AM - edited 03-06-2019 08:48 AM
spanning-treemode rapid-pvst
spanning-tree extend system-id
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
spanning-tree vlan 1-2,100,110,120,130,140,150 priority 24576
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
diagnostic bootup level minimal
!
I don't want to have the second spanning-tree vlan line to show up at all. They were added but we are changing and will not even have those VLANs on this switch.
I did the "no" command but it just added another annoying line of code.
Any suggestions?
James
Solved! Go to Solution.
12-02-2009 08:49 AM
Try this in config mode:
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
That should do it.
12-02-2009 08:36 AM
James,
If you are not able to remove all with one command, then try removing them one at the time
HTH
Reza
12-02-2009 08:49 AM
Try this in config mode:
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
That should do it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: