I have a couple RVS4000's and I use one of them as a router on a stick with two VLANs in it.
Two VLANs works fine.
However, when I add another VLAN, it will not route it.
I looked in the routing table and it doesn't show any routes for the new VLAN.
I can see the routes for the other two VLANs but my third VLAN is nonexistent.
The most I can get it to do is ping the routers VLAN IP interface.
I can't access the switches' interface on that VLAN or anything else on the new VLAN.
Is this a known problem?
Does this thing only route two VLANs?