12-03-2009 07:01 PM - edited 03-15-2019 08:40 PM
Can an inbound pstn caller to a voice gateway receive a busy signal if the end point ip phone is in a different location and call admission has been instituted across locations?
12-03-2009 07:40 PM
You need to tell what you use for call control, is this CME? CUCM? version?
HTH
java
if this helps, please rate
www.cisco.com/go/pdihelpdesk
12-04-2009 05:36 AM
CM 6.X location bandwidth control
12-04-2009 07:48 AM
Yes, configure the GW in locationA, the other phones in locationB.
Set the the codec between regions and the calculate how much BW to configure in the locations.
If the call from GW is the N+1 call supported with the BW it will fail and receive reorder, in case it was an ip phone you'll get a message explaining there is no BW.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: