CUCM 7.1(3) and *69, *67, *57, etc.

Unanswered Question
Dec 4th, 2009
User Badges:

I've been asked to look into whether or not certain phone features like last-call return (*69) etc. work through our phones.  I set up a route pattern for *69 and it works, although it takes a while to dial due to the fact that it's only 3 digits.  Is there a way to force it to dial rather than timing out and then dialing?


Also, are there any documents or recommendations or setting up these telco features with CUCM?


Thanks


Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Fri, 12/04/2009 - 10:50
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

It's weird it waits the IDT, the only explanation would be that there are other DNs in your CUCM that also start with *.

You can certainly configure those DNs as route patterns and check the urgent priority to have them go immediately


HTH


java


If this helps, please rate


www.cisco.com/go/pdihelpdesk

Actions

This Discussion