I currently do not have access to the router as I'm offsite and remote access is not enabled. Have to wait until tonight to get more logs.

When I try to ping 192.168.16.5 from 192.168.1.13 to bring up the tunnel I get no response. I had a console session to the router a couple of nights ago and it appeared as though the Phase 1 was not authenticating properly.......

I'm still learning this Cisco IOS admin stuff, so what commands can I use to get more information?

Thanks,

David

A few extra details:

I want to use pre-shared key initially while I get this working.

I want all internet traffic to use the DSL. I want all traffic from each of the LAN networks to be routed over the ipsec. No ports should be by access lists between the 2 LAN's.

I've attached the latest config from the C877.

I cannot get the tunnel to come up. If I do a ping to 192.168.16.5 (online on the remote site) and enable crypto debug on the Cisco it just keeps on trying to authenticate.

Can anyone assist?