FXO Port not going onhook

Unanswered Question
Dec 8th, 2009
User Badges:


I'm located in Belgium TelCo is Belgacom.

I have a PSTN line connected to an FXO port.

The problem is when I dial that line from my mobile and then hang up after a few rings, the IP Phone at the other end keeps ringing for some time (+- 10 seconds).

It seems that it doesn't detect the onhook signal form the PSTN line.

Here is what I have on my config file for that port.

voice-port 0/2/0
cptone BE
timeouts call-disconnect 5
timeouts wait-release 5
impedance complex2
bearer-cap Speech
caller-id enable

Anything I'm missing ? Should I remove something ?

Thank you for your help



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marcos Hernandez Tue, 12/08/2009 - 08:10
User Badges:
  • Blue, 1500 points or more

Are you dialing in, getting dial tone and then dialing again the internal IP phone extension?


This Discussion

Related Content