AnyConnect vpn client windows vista x64

Unanswered Question
Dec 8th, 2009

Need some assistance in trying to make Cisco Any Connect 2.3 standalone client work for Vista x64.

Can't seem to make it work.  I don't think it is hitting the ASA at all, so the problem is local to my pc.


1) Updated applicable HOTFIX for vista SP1

2) Remote routing disable

3) Adapter enable for vpn client

Anything else that I might need to address ?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
tprendergast Fri, 12/11/2009 - 11:15

Check the windows firewall. Make sure to test with it disabled. This drove a few people batty in the past.

If that doesn't work, please elaborate on your situation a bit more for us. What have you tried, what have you observed, etc.

xayavongp Fri, 12/11/2009 - 11:21

I figured it out.  I had to change the port on the AnyConnect portion of the configuration.

The default port (443) was being used by another app server via static translation.  Then I had to input x.x.x.x : "port number" on the

Anyconnect vpn client.  Didn't realize you could do that to launch it. Thanks-


This Discussion