12-08-2009 04:30 PM - edited 03-06-2019 08:52 AM
we have two routes for one of the destination. But i am not able to see one route in my topology table., what might be the cause.Thanks in advance.
Routing protocol : Eigrp
12-08-2009 04:37 PM
we have two routes for one of the destination. But i am not able to see one route in my topology table., what might be the cause.Thanks in advance.
Routing protocol : Eigrp
Could you be more specific.
Do you mean you have 2 equal cost path routes but you are only seeing one in the routing table
OR
do you mean you have 2 routes to a destination but when you look at the topology table you only see on route. If so are you using the command "sh ip eigrp topoology all-links" because without the all-links you will only see the successor and feasible successor routes.
Jon
12-08-2009 04:42 PM
yes, i have 2 routes to a destination but when i look at the topology table i can see only one route...
12-08-2009 04:43 PM
What command are you using to look at the topology table ?
Jon
12-08-2009 04:48 PM
sh ip eigrp top xx.xx.xx.xx mask
12-08-2009 04:53 PM
sh ip eigrp top xx.xx.xx.xx mask
Could you read my original post about "sh ip eigrp topology all-links"
Jon
12-09-2009 08:20 AM
jon.marshall wrote:
Could you read my original post about "sh ip eigrp topology all-links"
Jon
Hi Jon,
I am not sure if this is IOS specific but on most of the IOS versions that I have tried the 'show ip eigrp topo
12-09-2009 12:59 PM
Hi jon,
The route is not available only for particular destination , I can see it in sh ip eigrp top
12-09-2009 01:05 PM
vdadlaney wrote:
jon.marshall wrote:
Could you read my original post about "sh ip eigrp topology all-links"
Jon
Hi Jon,
I am not sure if this is IOS specific but on most of the IOS versions that I have tried the 'show ip eigrp topo
' displays all the routes not just the feasible successor. I believe the "show ip eigrp top all-links" command is equal to the "show ip eigpr top" without specifying the actual network and mask. Appreciate if you can can confirm if you know otherwise as I have always used the show ip eigrp top to troubleshoot such scenarios. thx for your help.
Must admit from memory i thought that only the all-links and detail-links options showed all routes learnt via EIGRP. You've got me thinking now so i'll have to lab it up and get back to you
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide