12-09-2009 02:25 AM - edited 03-11-2019 09:46 AM
Hi,
can someone confirm me that when I do an license upgrade from 20 to 50 contexts in a FWSM, I don't need to do a reload?
Thank you.
Best regards,
12-09-2009 03:33 AM
NorbertoSalgado wrote:
Hi,
can someone confirm me that when I do an license upgrade from 20 to 50 contexts in a FWSM, I don't need to do a reload?
Thank you.
Best regards,
Noberto
When you enter a new activation key you have to reload the firewall before that activation key takes effect.
Jon
12-09-2009 03:43 AM
Hi,
my doubt it's because I read in this document: http://www.cisco.com/en/US/docs/security/asdm/6_2/user/guide/license.html#wp1273162
that the reload it's only required in the following situations:
But it's needed in all licenses upgrade then?
Thank you.
Best regards,
12-09-2009 03:49 AM
NorbertoSalgado wrote:
Hi,
my doubt it's because I read in this document: http://www.cisco.com/en/US/docs/security/asdm/6_2/user/guide/license.html#wp1273162
that the reload it's only required in the following situations:
# Model | # License Action Requiring Reload |
---|---|
# ASA 5505 and ASA 5510 | # Changing between the Base and Security Plus license. |
# All models | # Changing the Encryption license. |
# All models | # Downgrading any license (for example, going from 10 contexts to 2 contexts). ##Note If a temporary license expires, and the permanent license is a downgrade, then you do not need to immediately reload the security appliance; the next time you reload, the permanent license is restored. |
But it's needed in all licenses upgrade then?
Thank you.
Best regards,
Noberto
I think that applies only to ASA models. From the 3.1 FWSM configuration guide -
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: