1131 AP Shows as having "other" antenna in the WCS

Unanswered Question

I just installed 5 lightweight 1131 ap's, two of them show up as having " other " as the antenna type in my WCS , the others show as having Ajax-Omni. They all have the same code and were installed at the same time. Also I can't get a het map profile from the " other " listed AP's. Can anyone help?

Thanks

Bill

I have this problem too.
1 vote
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nael Mohammad Thu, 12/17/2009 - 09:58

1. You can go to Monitor Map ---> Campus ---> Select Building ---> Select Floor ---> From the drop down menu select command, choose "Position AP" and Go .

2. Click on the problematic AP's 1131 and select the correct Antenna type as being "AJAX-OMNI" which the image should match for AIR-LAP1131AG-A-K9.

3. Click Save and the heat map should start to populate.

4. From Floor Settings, select Access Points --> Protocol "802.11b/g/n" or 802.11a/n but not both. It's has to be one or the other else the heat maps will not display.

5. From Floor Settings ---> AP Heatmaps --> Contributing APs, Select ALL the APs and OK.

-nael

Actions

This Discussion