How do I connect DeskTop/PC to a 3750 switch to support multiple VLAN and be able to ping a LO interface?
Can anyone advise me the best way to configure a (C3750 IPServices) IOS 12.2(25) to interface with a Desk Top doing .1Q tagging? And to be able to PING a LO once multiple VLAN’s are configured??
* With the below configuration connected, when I ping 10.2.1.1 (LO1) from the PC the switch see’s in the ARP table 10.2.1.255. Hence, does not echo ping back. So PING is unsuccessful not reaching the loop back interface. Seems the port or the NIC card are not functioning correct. This is where I am at now. Not getting much help from the Microsoft forums. The reason I am doing this is more complex, I am trying to set up virtual machines on a single PC with multiple VLANID’s but before I can even get to that, I cannot even get the PC to successfully ping a LO int by it self.
What I have done so far is this:
Windows XP Desk Top Config:
Configured VLAN (10.1.1.2) on PC running Win XP w/1gig NIC supports .1Q.
Current configuration : 1784 bytes
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
no aaa new-model
switch 1 provision ws-c3750g-24ts-1u
no file verify auto
spanning-tree mode pvst
spanning-tree extend system-id
vlan internal allocation policy ascending
ip address 10.2.1.1 255.255.255.255
interface GigabitEthernet1/0/1 (this is the port PC is connected to)
switchport trunk encapsulation dot1q
switchport mode trunk
interface GigabitEthernet1/0/2 ( I read somewhere that Access port will support multiple VLANs now. I am not sure about this maybe with VoIP and Data only please advise)
switchport access vlan 10
switchport mode access
no ip address
ip address 10.1.1.1 255.255.255.0
ip address 10.1.2.1 255.255.255.0
ip address 10.1.3.1 255.255.255.0
ip http server
line con 0
line vty 0 4
line vty 5 15