PIX change management software

Unanswered Question
Dec 9th, 2009
User Badges:

Hi, i have Cisco works LMS3.0,

i have added all routers switches, and after every 24 hours, all changes to my routers switches, i get that via email,

but i dont see any change report of cisco pix firewall.

dont LMS3.0 support firewall changes ? am i missing some thing? or i need some other software to do that?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ahmad82pkn Tue, 12/15/2009 - 15:32
User Badges:

Thank you for the information, But i dont get change report , though devices are added in same way as of Routers,

Do i need to do any additional confoguration on firewall, except SNMP string and specifying IP address of server running LMS and its interface name inside in my case?

in my PIX i have this confoguration, router confoguration change report comes fine, with same set of information configured in router/switches.

snmp-server host inside x.x.x.x community abcd

snmp-server community abcd

Farrukh Haroon Tue, 12/15/2009 - 22:17
User Badges:
  • Red, 2250 points or more

Do one thing, go to the Device Center >> Select the 'Firewall' and then click on 'View Config' Is RME collecting any

configs at all for your firewall?  You can also check this from RME directly.




This Discussion