12-10-2009 09:03 AM - edited 03-04-2019 06:56 AM
Hi Guys,
I'm not very familiar with this card, I have this problem , when i type sh ip int brief ;
rtr2#sh ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 172.21.40.5 YES NVRAM up up
GigabitEthernet0/1 172.21.40.5 YES NVRAM standby mode down
Serial1/0:0 10.20.197.1 YES manual reset down
Serial1/1:0 unassigned YES manual administratively down down
Serial2/0:0 unassigned YES manual administratively down down
Serial2/1:0 unassigned YES unset reset down
Serial3/0:0 unassigned YES unset reset down
Serial3/1:0 unassigned YES unset reset down
Serial4/0 unassigned YES manual down down
Serial4/1 unassigned YES manual down down
Serial4/2 unassigned YES unset administratively down down
Serial4/3 unassigned YES unset administratively down down
NVI0 unassigned YES unset up up
Multilink120 172.21.80.1 YES manual down down
may i know what does this reset mean instead of down status?
Thanks!
12-10-2009 09:24 AM
Hi,
what model of router is this?
did you tried an OIR ?
I have seen this happening when OIR is not supported, so a reload of the box is needed.
or when having a faulty card.
please send more details of the issue, like show version, and steps applied to this card so far.
regards
Yesua.
12-10-2009 10:52 AM
Hi Yesua,
The router is 3825 running ios ver Version 12.4(1c), config i believe is correct..
.
.
.
card type e1 1
card type e1 2
card type e1 3
.
.
.
.!
controller E1 1/0
line-termination 75-ohm
channel-group 0 unframed
!
controller E1 1/1
line-termination 75-ohm
channel-group 0 unframed
!
controller E1 2/0
channel-group 0 unframed
!
controller E1 2/1
channel-group 0 unframed
!
controller E1 3/0
channel-group 0 unframed
!
controller E1 3/1
channel-group 0 unframed
..
.
.
interface Serial1/0:0
description E1 to Balun 28-A-1 (MCB)
bandwidth 2048
ip address 10.20.X.X 255.255.255.252
ip access-group 199 in
ip nat outside
no cdp enable
!
interface Serial1/1:0
no ip address
shutdown
!
interface Serial2/0:0
no ip address
shutdown
..
I not remove or insert the module..
The RA led is amber, could it be the remote side down?
Thanks
12-10-2009 11:02 AM
Take "show controllers E1".
Most likely, bad cable or circuit failure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide