VRRP and MAC address issue

Unanswered Question
Dec 10th, 2009
User Badges:

We have 2 switches (Switch 1 & 2) on our end and another 2 switches (Switch 3 & 4) on another end.

Tried running VRRP on Switch 1 & 2, but there seemed to be some mac address issue when failing over (Suspect a spanning port blocking issue)

Is the attached setup valid ?

Is there a way to set up redundancy using the 2 MetroEthernet lines.

Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Fri, 12/11/2009 - 10:33
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

What is the error you have encountered in switch 1 and 2 and redundancy can be achived by top two switches itself.


Regards

Ganesh.H

ciscodotty Fri, 12/11/2009 - 18:59
User Badges:

I was told there isn't a problem on our end, but rather the problem happened over Sw 3 and 4 which is not managed by us. I suspect that the one of the ports was in blocking mode. Could I be right in my suspicion?


Bear in mind that the Vlan 123 are over MetroEthernet lines.

Actions

This Discussion