12-10-2009 10:40 PM - edited 03-06-2019 08:54 AM
We have 2 switches (Switch 1 & 2) on our end and another 2 switches (Switch 3 & 4) on another end.
Tried running VRRP on Switch 1 & 2, but there seemed to be some mac address issue when failing over (Suspect a spanning port blocking issue)
Is the attached setup valid ?
Is there a way to set up redundancy using the 2 MetroEthernet lines.
12-11-2009 10:33 AM
What is the error you have encountered in switch 1 and 2 and redundancy can be achived by top two switches itself.
Regards
Ganesh.H
12-11-2009 06:59 PM
I was told there isn't a problem on our end, but rather the problem happened over Sw 3 and 4 which is not managed by us. I suspect that the one of the ports was in blocking mode. Could I be right in my suspicion?
Bear in mind that the Vlan 123 are over MetroEthernet lines.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: