1230AG non-root bridge not associating

Unanswered Question
Dec 14th, 2009

Hello everyone,

I am new at setting up root and non-root bridges. I am trying to set-up three 1230ag devices.

One as the root and the othe two as non-root, I copied the config txt from the root and

copied that into the two I am going to use for the non-root. That way the ssid's are the

same. When I set the role to non-root the radio is not enabled and I get a message saying

Interface Dot11Radio0,cannot associate:No Response

Does any know what I am doing wrong, and how to fix it


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jeff.kish Wed, 12/16/2009 - 14:20

The radio interface will go down in response to being configured as a non-root bridge, so that much is working.  But there must be a configuration error if it won't associate.  Can you post the configs so we can review them?

Are the bridges mounted, or are they on your desk?

steinmetzssj Thu, 12/17/2009 - 08:28

Right now they are on my desk, But even when they are mounted they still don't associate

The attached files are for the root and non-root bridges.

Thanks for your help.




This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode