Frame Relay - RV016

Unanswered Question
Dec 15th, 2009
User Badges:

Dears, I would like to know if I can configure the router linksy - Cisco to receive a Frame Relay link?

The protocol is sent pel PPP provider as part of a configuration below, which I received from the provider.

Protocol MLPPP / Routing / Static Routing Balancing NO / Address Block (LAN) 192.168.4.0 / Address Mask 255.255.255.0 / Topology Full MeshedQoS NO.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Mon, 12/28/2009 - 01:12
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Mauricio,

after reading the service provider specifications I would say you should configure your device with encapsulation PPP or multilink PPP rather then frame relay.

It is possible to run PPP over Frame Relay but I don't know if this is your case.


Hope to help

Giuseppe

Actions

This Discussion