Verifying Syslog automated actions

Answered Question
Dec 15th, 2009
User Badges:

Dear friends,


I have some sylog messages on which i am defining an automated action. I just want to make sure that they are right.


The syslog messages that i want to try are:


1. %BGP-5-ADJCHANGE
2. %BGP-3-NOTIFICATION


Can you tell me if my settings under RME-->Tools-->Syslog-->Automated action is right?


Facility: BGP

Sub-facility: *

Seveirity : *

Mnemonic: ADJCHANGE ,NOTIFICATION



Thanks a lot

Gautam

Correct Answer by luijimen about 7 years 4 months ago

Hi Gautam,


You almost nailed it. Try the following settings instead:


Facility: BGP

Subfacility: *

Severity: 5

Mnemonic: ADJCHANG

Description:*


Facility: BGP

Subfacility: *

Severity: 3

Mnemonic: NOTIFICATION

Description:*


You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.


Regards,


Luis.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
luijimen Tue, 12/15/2009 - 14:52
User Badges:
  • Cisco Employee,

Hi Gautam,


You almost nailed it. Try the following settings instead:


Facility: BGP

Subfacility: *

Severity: 5

Mnemonic: ADJCHANG

Description:*


Facility: BGP

Subfacility: *

Severity: 3

Mnemonic: NOTIFICATION

Description:*


You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.


Regards,


Luis.

gautamzone Tue, 12/15/2009 - 22:04
User Badges:

Thanks a lot Luis for your wonderful support.



Thanks and Regards

Gautam

Actions

This Discussion