12-15-2009 02:15 PM
Dear friends,
I have some sylog messages on which i am defining an automated action. I just want to make sure that they are right.
The syslog messages that i want to try are:
1. %BGP-5-ADJCHANGE
2. %BGP-3-NOTIFICATION
Can you tell me if my settings under RME-->Tools-->Syslog-->Automated action is right?
Facility: BGP
Sub-facility: *
Seveirity : *
Mnemonic: ADJCHANGE ,NOTIFICATION
Thanks a lot
Gautam
Solved! Go to Solution.
12-15-2009 02:52 PM
Hi Gautam,
You almost nailed it. Try the following settings instead:
Facility: BGP
Subfacility: *
Severity: 5
Mnemonic: ADJCHANG
Description:*
Facility: BGP
Subfacility: *
Severity: 3
Mnemonic: NOTIFICATION
Description:*
You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.
Regards,
Luis.
12-15-2009 02:52 PM
Hi Gautam,
You almost nailed it. Try the following settings instead:
Facility: BGP
Subfacility: *
Severity: 5
Mnemonic: ADJCHANG
Description:*
Facility: BGP
Subfacility: *
Severity: 3
Mnemonic: NOTIFICATION
Description:*
You will need to create 2 separate lines, one for each syslog message type. The above should match the same messages you mentioned.
Regards,
Luis.
12-15-2009 10:04 PM
Thanks a lot Luis for your wonderful support.
Thanks and Regards
Gautam
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: