upgd an LWAPP 1130AP (4.2.130/4.2.176) to 6.0 and back down to 4.2.130

Unanswered Question
Dec 16th, 2009
User Badges:

Greetings,


I'm about to upgrade the code on 2 WiSM WLC's from 4.2.130 to 4.2.176 and then to 6.0.182. Then move these 2 WLC's to a new mobility group which will be created as well. After creating the mobility groups, I plan on moving ONLY 4 -1130's from an existing mobility group over to the new mobility group.


Q1 - Is it best practice to have the 1130 LWAPP AP's join the 4.2.176 prior to joining the 6.0.182 or does it really matter?

Q2 - Also, should I attach the 1130's to the upgraded controllers prior to creating the new mobility goups or after ?

Q3 - Lastly, are there any caveats from downgrading an 1130 LWAPP AP from 6.0.182 back to 4.2.130?


Thanks


-RC

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 12/16/2009 - 13:50
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Hi Richard,


1.  Doesn't matter.
2.  After the upgrade. 
3.  Yes.  There's a significant chance of you loosing your configuration.  If I were you, wipe the config clean, downgrade the firmware and then re-configure.  This minimize the risk of some codes getting broken during the downgrade process.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode