I managed to delete the flash on my aironet 1200 series WAP and is really struggeling to get the flash loaded back on to the device.
When the ap boots up it goes into "ap mode" as there's no bootable files.
I've unplugged the power and held the mode button in while powering up the ap (for about 20-30sec) - all leds at the back goes green (status,radio,eth).
When I try to load the flash with xmodem its says access denied - when I issue the ap: "dir" command it shows xmodem as (read-only).
I've also assigned myself an ip address of 10.0.0.2 and tried to ping the ap on the default ip address of 10.0.0.1 but no luck. (so tftp is also out of the question)..
Any suggestions would be highly appriciated!