Cisco ITP /without Serial interface

Unanswered Question
Dec 17th, 2009

Hello

I'd like to ask if it's possible to configure SCTP/M3UA on Cisco 2811 but without any serial kind of interface,only by using one Ethernet port ?

According to the document :

http://www.cisco.com/en/US/docs/wireless/itp/RNsPDFs/RNSW4.pdf

(Caveats CSCsr01623,page 18)

Basically,I'd like just to configure one M3UA connection to far end,and do not want to connect to any TDM/E1 links,just using the SS7overIP/SIGTRAN protocols ?

Sincerely

Dragan Zubac

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
zubacdragan Thu, 12/24/2009 - 07:57

Hello

Thank You for the information. I'm not sure,but it seems that Cisco ITP will not allow You to configure SCTP/M3UA in client mode,only in server mode.

When I did configured an example SCTP/M3UA connection,I was able to connect to Cisco with M3UA client application,but I was unable to make Cisco ITP to connect to far end M3UA server.

Guess it means that Cisco ITP can be used only as SCTP/M3UA server and not as a client as well ?

Regarding SCTP/M2PA ,Cisco ITP is capable to act as both server and client as well.

Sincerely

Dragan Zubac

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode