How to configure Ciscoworks to backup a Netacs appliance?

REUBEN CHIN · ‎12-17-2009

I've got a TAC case already opened on this, but if anyone knows how I can get CiscoWorks to do this it would be greatly appreciated.

Simply put, I would like the Netacs appliance to appear as all the other devices I have within Ciscoworks. Of course the Netacs already preforms an automatic backup to a specified remote location, but I was wondering or would like to keep all the configs / inventory managed within CiscoWorks.

Anyways, if it's not doable I'll live with the current setup but just had to ask to explore the possibilities if any.

Thanks,

Reuben

Nael Mohammad · ‎12-17-2009

If it's not listed in the Supported Device Table for LMS 3.2, it's not supported.

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/device_support/table/lms32sdt.html

REUBEN CHIN · ‎12-17-2009

Thanks Nael.

Just spoke with Cisco TAC and they said the ACS device is not supported. I'll check your doc as well - good advice. Thank you again.

Reuben