I have configured an RSPAN monitoring session on a 2950 switch. I have configured a remote-span VLAN from the VTP server switch, and checked on my monitoring source switch (VTP client in the domain) that the VLAN shows up as a remote-span VLAN.
I have configured the reflector port on the client, and the destination port and source remote-vlan on the server.
No matter what VLAN I assign to the destination port - remote-span VLAN, vlan of the monitored source-port, no VLAN id at all, I only get Broadcast and multicast traffic forwarded to my monitor (wireshark).
I've seen various discussions of this over the last coupe of years, but no definitive answe (e.g. https://supportforums.cisco.com/message/544295#147017)
Has anyone got any further thoughts?
you have been kind to provide a feedback on this issue.
Probably other people may meet the same problem.
RSPAN is supported only on enhanced image:
To use the RSPAN feature described in this section, you must have the EI installed on your switch. Follow these guidelines when configuring RSPAN:
what image have you got?
post sh ver | inc image
Hope to help